Specifications
OWNER’S GUIDE SIGNAL/SENSOR ADAPTERS | 11275
Adapters for various MDAQ and DAQ series modules
MDAQ-SUB-
STG-D
MDAQ-SUB-
BRIDGE-D
MDAQ-SUB-
V200-D
MDAQ-SUB-
V200-BNC
DAQP-LV-B
DAQP-LV-
BNC
DAQP-LV-D DAQP-STG-D
Adapter from banana jack to BNC.
Allows you to connect your cables with banana plugs into Dewetron modules which have BNC input connectors.
ADAP-MIC-BNC-CBL -- -- -- √ -- √ -- --
Microphone adapter and 6 ft BNC cable. Allows the use of standard unpowered mics with your Dewetron system.
Adapter: 3 Pin XLR Male to BNC Female Audio Adapter
Contacts (XLR) : 3 Genders: BNC (Female) / XLR (Male) Wired: Pin 1 & 3 = Ground / Pin 2 = Hot
Includes 6 ft BNC-BNC cable (not shown in picture here)
ADAP-BR-1/4-120 not needed √ -- -- -- -- -- not needed
Bridge completion terminal, 1/4 bridge @ 120 Ω
DSUB9 input and output connectors
ADAP-BR-1/4-350 not needed √ -- -- -- -- -- not needed
Bridge completion terminal, 1/4 bridge @ 350 Ω
DSUB9 input and output connectors
Using Adapters in DS-7
Since ADAP adapters do not have any kind of electronic interface, they do not show up in the software
automatically - you have to set them up yourself. But DEWESoft makes this easy. Simply access the SETUP
screen for any channel that you have an adapter plugged into, and enter the appropriate settings and scal-
ing information there.
In the next section we will look at setting up a few popular adapters in the most commonly requested sce-
narios.