Specifications

11-274 | OWNER’S GUIDE
Adapters for various MDAQ and DAQ series modules
MDAQ-SUB-
STG-D
MDAQ-SUB-
BRIDGE-D
MDAQ-SUB-
V200-D
MDAQ-SUB-
V200-BNC
DAQP-LV-B
DAQP-LV-
BNC
DAQP-LV-D DAQP-STG-D
DAQ-SHUNT-1 --
--
-- -- √ -- -- --
Shunt adapter for 0-20 mA or 4-20 mA measurements, internal precision 50Ω shunt resistor
100 mA input range, 1 W maximum, 1% accuracy
banana plug to Dewetron module / banana jacks on sensor side
DAQ-SHUNT-1-BNC √ √ √ -- -- -- √ √
Shunt adapter for 0-20 mA or 4-20 mA measurements, internal precision 50Ω shunt resistor
100 mA input range, 1 W maximum, 1% accuracy
9-pin DSUB to Dewetron module / BNC jack on sensor side
DAQ-SHUNT-3 -- -- -- -- √ -- -- --
Shunt box for measurements up to 5A (0.1 Ω, ±0.1%, 3W)
Current input via 2 x 0.3 meter cables with banana plugs
Voltage output via 2 x 0.3 meter cable with banana plugs
DAQ-SHUNT-4 -- -- -- √ -- -- --
Shunt box for measurements up to 5A (0.1 Ω, ±0.1%, 3W)
Current input via 2 x safety banana jacks
Voltage output via 2 x 0.3 meter cable with banana plugs
DAQ-SHUNT-5 -- -- -- √ -- -- --
Shunt box for measurements up to 5A (0.1 Ω, ±0.1%, 3W)
Current input via 2 x safety banana jacks
Voltage output via 2 x safety banana jacks
CONN-DSUB-9 √ √ √ -- -- -- √ √
Mating connector for 9-pin DSUB connectors with convenient screw terminals inside
Eliminates soldering/desoldering
ADAP-MDAQ-BNC √ √ √ -- -- -- -- --
Converter from 9-pin DSUB to BNC input connector, for MDAQ series modules
(pin-outs are the same as ADAP-DAQ-BNC, but there is an additional isolation resistor in this adapter to improve noise performance of
differential MDAQ series modules)
ADAP-DAQ-BNC -- -- -- -- -- -- √ √
Converter from 9-pin DSUB to BNC input connector, for DAQ series modules
ADAP-BAN-BNC -- -- -- √ not needed √ -- --