Specifications

9-196 | OWNER’S GUIDE
Notice that four screens are created for you by default. click on the Scope, Recorder, and FFT screens and
see how they are set up by default. You can change everything about these screens as mentioned earlier,
but for now let’s use them as they are, and then come back to the design functions later.
1. RIBBON AND TOOLBAR - contains the DEWESoft ribbon, where you can navigate among the setup
screens, display screens, and design mode. Also contains the toolbar, which has buttons to start and stop
storing data, and select which screen to display.
2. PROPERTIES BAR - where you can set the properties of any display widget in the Data display area, as
well as the properties of each display screen
3. DATA DISPLAY AREA - where your signals are shown, according to which display screen has been se-
lected from the toolbar
4. CHANNEL LIST - shows your channels, and allows you to assign them into graphs and widgets.