Specifications
9-180 | OWNER’S GUIDE
PART 1: signal conditioner hardware control (top-right quadrant)
It is best to congure this section rst, because this actually con- trols
the signal conditioning HARDWARE. In the example above, we have
a DAQP-LV low voltage module, which has two basic input types: volt-
age and current.
Assuming we want to measure voltage, simply set the RANGE using
the selector:
Now set the lter (if you have an MDAQ system, you may or may not have the lter option). Different signal
conditioners have different settings, so please refer to the details about them. In this quick start we will just
use voltage modules and keep it simple.
In our example we set the range to 50V. Have a look at the reference section and you will see this on the
LEFT SIDE of the bar graph. Note that if you change the range, this will change directly below on the bar
graph: