Specifications
OWNER’S GUIDE DEWE3040RM | 7145
Operation Guidelines
System Startup Protocol
Plug the standard AC power cord into a valid
mains power source.
⇒ Do not block the cooling fans of the DEWE-3040-RM.
Overheating any electrical component is dangerous.
Turning on the System
The MASTER power switch must be set to the on
position. Now locate the smaller soft power switch
nearby on the front panel. This is a momentary
rocker type switch, where the white dot indicates the
ON direction.
♦ Press ON and hold for one second to power the
system on.
♦ Press ON and hold for 3 seconds to power OFF.
♦ Green POWER LED: lit when the system is
powered on
Hardware Protocols
Using the removable hard disk drives
The front panel of the DEWE-3040-RM has a 2.5”
removable drive bay.
⇒ Never remove the C drive when the system is
powered on or plugged in! The operating system
can become corrupted and the system will fail if you
do this. It’s always safer to completely turn o the
system before removing or installing any hard drive.
To remove the hard drive, you must have access
to the keylock. Turn the key into the lock and then
press the large button beside the lock to eject the
drive. To insert another drive, reverse these steps.
The front panel of the DEWE-3040-RM is where the soft
power switch is located.
The rear panel of the DEWE-3040-RM is where the
MASTER power switch is located.
The front panel of the DEWE-3040-RM is where the
removable hard disk drive is located.