Specifications
7-144 |
When the CAN option is installed, this single LEMO connector will contain two CAN BUS interfaces. The
CAN-CBL-Y mating cable is optionally available to split the single LEMO connector to two standard CAN
DB-9 (female) connectors. Both DB-9 connectors are wired the same way, as shown below:
When you connect either CAN bus interface to your vehicle or other CAN network, it is necessary to add
termination resistors (not included) at each end of the cable:
- Note: this connector does not provide power for CPAD2 series modules.
Digital I/O connector (AKA “Accessory connector”)
Connector: Standard DSUB 37-pin connector, female
Mating connector: Standard DSUB 37-pin connector, female
Function: Provides access to the digital input/output lines on the installed A/D card, as well as additional
signals such as clock input, trigger input, and more (see A/D card table related to the installed card).
The exact pin-out of this connector can vary according to the system conguration, but here is the typical
pin-out diagram when an ORION-1616-100 card is installed: