Specifications

OWNER’S GUIDE  SECTION 2, SAFETY PRECAUTIONS | 213
2
Safety precautions
Your safety is our primary concern! Please be safe at
all times.
General safety and hazard warnings for all Dewetron
systems:
Symbols used in this manual:
Indicates hazardous voltages
WARNING
Calls attention to a procedure, practice, or condition
that could cause bodily injury or death.
CAUTION
Calls attention to a procedure, practice, or condition
that could possibly cause damage to equipment or
permanent loss of data.
⇒ These notices are sometimes indicated in this
graphical motif.
The following general safety precautions must be
observed during all phases of operation, service,
and repair of this product. Failure to comply with
these precautions or with specic warnings else-
where in this manual violates safety standards
of design, manufacture, and intended use of the
product. DEWETRON Elektronische Messgeraete
Ges.m.b.H. assumes no liability for the customer’s
failure to comply with these requirements.
♦ Use this system under the terms of the specications only to
avoid any possible danger. Maintenance should be performed
by qualied personnel only.
♦ During the use of the system, it might be possible to interact
with non-Dewetron systems. Please read and follow the safety
instructions provided in the manuals of all other components
regarding warning and security advices for using the system.
♦ With this product, only use the power cable delivered or de-
ned for the host country.
♦ Do not connect or disconnect sensors, probes or test leads, as
these parts are connected to a voltage supply unit.
♦ The system is grounded via a protective conductor in the
power supply cord. To avoid electric shocks, the protective
conductor must be connected with the ground of the power
network. Before connecting the input or output connectors
of the system, make sure that there is a proper grounding to
guarantee potential free usage. For countries, in which there is
no proper grounding, please refere to your local legally safety
regulations for safety use.
♦ DC systems: Every DC system has a grounding connected to
the chassis (yellow/green safety banana plug).
♦ Please note the characteristics and indicators on the system
to avoid re or electric shocks. Before connecting the system,
please carefully read the corresponding specications in the
product manual.
♦ The inputs are not, unless otherwise noted (CATx identica-
tion), for connecting to the main circuit of category II, III and IV.
♦ The power cord separates the system from the power supply.
Do not block the power cord, since it has to be accessible for
the users.
♦ Do not use the system if equipment covers or shields are
removed.
♦ If you assume the system is damaged, get it examined by
authorized personnel only.
♦ Any use in wet rooms, outdoors or in adverse environmental
condition is not allowed! Adverse environmental conditions are:
moisture or high humidity, dust, ammable gases, fumes or
storms. et al.