Specifications

6-124 | OWNER’S GUIDE
Turning on the System
The MASTER power switch must be set to the on
position. Now locate the smaller soft power switch
nearby on the left side panel. This is a momentary
rocker type switch, where the white dot indicates the
ON direction.
♦ Press ON and hold for one second to power the
system on.
♦ Press ON and hold for 3 seconds to power OFF.
♦ Green POWER LED: lit when the system is
powered on
- The LCD battery display is ALWAYS on when any bat-
teries are installed. This does not indicate that the
system is powered on! Only the green POWER LED
indicates system power on/o status.
You may notice that the main screen’s backlight will
come on when power is applied. After a few mo-
ments the BIOS and Windows operating system
messages and graphics will appear.
⇒ If the system does not power on, ensure that you
have batteries with at least 30% charge, or that the
DPS-2410 is properly connected and TURNED ON.
Hardware Protocols
Using the removable hard disk drives
The left side of the DEWE-3050 has two 2.5” remov-
able drive bays. One is marked as the C drive for
Windows and applications, and the other as the D
drive for data.
⇒ Never remove the C drive when the system is
powered on or plugged in! The operating system
can become corrupted and the system will fail if
you do this. Also take care with the D drive, that no
application is trying to access it. It’s always safer to
completely turn o the system before removing or
installing any hard drive.
To remove the hard drive, you must have access
to the keylock. Turn the key into the lock and then
press the large button beside the lock to eject the
drive. To insert another drive, reverse these steps.
The larger power switch is the MASTER. The smaller one is
a “soft,” or momentary type, located nearby, on the left side
panel. In between is a green LED which lights up to indicate
that system power is on.
The DEWE-3050 right side panel contains two removable
HDD s (hard disk drives).