Specifications

6-122 | OWNER’S GUIDE
Operation Guidelines
System Startup Protocol
Installing the Smart Batteries
Systems are shipped with the hot-swappable bat-
teries removed. You should install them, connect
power, and charge up the batteries. Please follow
these guidelines:
♦ Open the battery door on the side of the DEWE-
3050 and insert four SideHAND2 series smart
batteries into the four slots.
♦ When inserting the rst battery you may notice
that the system LEDs and fans will turn on for a
second, this is normal when the battery module
“wakes up.”
⇒ Never use any battery which appears to be dam-
aged, or which is cracked, broken, hot to the touch,
or unusual in any way. Lithium batteries can be
dangerous if mistreated or improperly charged.
Please locate the BATTERY STATUS LCD, located on
the left side panel.
♦ With batteries in place, the LCD screen will
display the charge level, charge/discharge state,
power consumption and total current.
♦ The LCD (and battery module circuit) will always
be ON, unless the batteries are removed
Plug the standard AC power cord into a valid
mains power source.
 Turn on the master power switch on the left side
panel.
 Press and release the smaller soft power switch
adjacent to the larger master power switch. The
system, will boot up.
⇒ Do not block the cooling fan of the DEWE-3050.
The battery door on the side of the DEWE-3050 is hinged,
allowing you to access the battery compartment. Batteries can
be removed by pulling on their flexible tabs.
The battery status LCD keeps you informed of how many
batteries are installed (2 above), the charge level (100%
above), and whether the system is charging or discharging.