Specifications

6-120 |
When the CAN option is installed, this single LEMO connector will contain two CAN BUS interfaces. The
CAN-CBL-Y mating cable is optionally available to split the single LEMO connector to two standard CAN
DB-9 (female) connectors. Both DB-9 connectors are wired the same way, as shown below:
When you connect either CAN bus interface to your vehicle or other CAN network, it is necessary to add
termination resistors (not included) at each end of the cable:
- Note: this connector does not provide power for CPAD2 series modules.
Digital I/O connector (AKA “Accessory connector”)