User guide

If an error occurs in the setting of the connection between OfficeServ Link V3
program and a switch, a message about the generated error appears on the status message
window. Each status information displayed on the status window has two types of the
indication icon.
일반메시지.ico 장애메시지.ico
General message Icon is a message that OfficeServ Link V3 usually informs to a user
and the fault message is a message that displays the fault generated during the
current link’s operation.
[그림 한글]
일반메시지.ico: general_message.ico/ 장애메시지.ico: fault_message.ico
If an error occurs during the procedure of the connection, OfficeServ Link V3 performs the
auto recovery procedure until the fault is recovered (or, within the range of the limited time
internally specified). If the auto recovery cannot be performed, a message about the error
generation is displayed on the status message window.
<Figure 4–5. Auto Recovery message after the Generation of Faults>
4.2 Disconnecting the connection between a switch and users
When a termination of the Link program is needed, a user can disconnect the connection
to a switch by selecting the Disconnect button 【
】. If the user select the
Disconnect button, the following button appears.
<Figure 4–6. Confirming the Termination of All Connections>
If you click the OK button, the Link displays the following window and disconnects the