User guide

If any error occurs during the setting of the switch connection, you can stop the
current connection attempt by pressing F11 button. This function is useful when
the connection of a specific switch is delayed while connecting a multiplex switch.
The switch whose connection is stopped attempts the auto connection according
to the procedure specified in the Auto Connection Recovery option.
<Figure 4–3. Setting the Connection with Switches>
If the connection of a switch is successfully performed, a message to tells the success of
the connection appears on the status message window as shown below:
<Figure 4–4. Success Message of the Switch Connection>
In addition, the connection status bar of OfficeServ Link V3 displays the number of the
normally connected switches like
, and the AVI picture 【 】 on
the bottom right is changed into the rotation shape. This shape indicates that the current
connection status is normal. If the connection is terminated or any error occurs, the
rotation shape of the AVI picture becomes in static mode. In addition, the Connect button
【
】 of V3 is changed into the Disconnect button 【 】.