User guide
Chapter 4. Use of OfficeServ Link V3
4.1 Connecting a Switch and Entering to the User Access Standby Mode.
After completing the communication environment setting, you can connect the OfficeServ
Link V3 to a switch by using the connect button γ
γfor Office Link V3
Connection. For the correct connection, the setting for the switch should be carried out in
advance before the connection to the switch.
If the above settings are completed, progress the connection to a switch by pressing the
connect button γ
γfor the link connection.
If all steps are normal, the following window appears after selecting the Connect button:
<Figure 4-1. Connection Confirmation Box >
If the Automatic Switch Connection function is set, the above confirmation
message does not appear.
If you select the OK button, OfficeServ Link V3 performs the connection work with the
switch by using the communication environment information previous set. The following
screen appears:
<Figure 4-2. Connection Progress Window>
The switch connection progress status bar appears for the maximum 60 seconds
at every switch to be connected. Therefore, the maximum eight units of switches
to be connected, the status bar can appear for 480 seconds (60 seconds x 8
units). If all switches are normally connected with in the above limited time, the
status bar is automatically disappeared.