User guide

<Figure 3–5 Switch Information Modification >
When the modification is completely performed, select the target application item
and save the information.
When the switch information is modified, the No. that is not used can be used
as the switch No. If the switch IP address is redundant to the switch already
registered, an error message is displayed.
<Figure 3–6 Switch Information Redundancy Error>
☞ Deleting a Switch
When the switch information saved is required to be deleted, this function is used.
Select the target switch from the list and click the (
) button to display the
deletion window. Select OK to delete the corresponding switch permanently.
<Figure 3–7 Switch Information Deletion Confirmation>
3.2.2 Basic switch selection
OfficeServ Link V3 uses two types of basic switch information, the basic switch
information set in the communication environment and the basic switch information of
each user, which is registered in user information management. The basic switch
information set in the communication environment is used for allowing the access of
single switch based application program that uses the existing OfficeServ Link V2 that is