User guide

Composer Pro User Guide
Copyright © 2011 Control4. All Rights Reserved.
Saved: 4/14/2011 4:10:00 PM
200-00005 Composer Pro
User Guide Part 2
Page 48 of 179
Audio Volume Not set
Bedroom
Audio End Point Mini Mini Touch Screen
Audio Volume Mini Touch Screen
Front
There are no video or audio End Points or any devices that can manage volume
in the Front room, so you don’t need to identify the video or audio source or
volume control device in that room, or modify the room for room connections.
3. Create a connection to define the other devices in the room where you want volume.
a. Select a room in the project tree.
b. In the Room Control list, select an item in the Control & Audio Video Connections, and then
drag it to an item in the lower list to connect the two (2) items. When successful, both lists are
updated to reflect the connection.
Example: From the top center pane, click Video Volume 2 (RoomControl—AUDIO_VOLUME),
and drag to the bottom center pane to connect it to Television (Room Selection - Output—
Theater).
5.3.4 Connecting Devices to the Network
After you complete your planning and design of a Control4
®
system (adding the buildings, rooms,
devices, etc. - see Composer Pro Getting Started for details), you are ready to make the necessary
connections in the system.
These sections provide information about connecting your devices to the Control4 system.
“Connecting Devices to the Network”
“Connecting and Managing Control and AV Devices”
“Connecting and Verifying Devices”
“Connecting Rooms”
5.3.4.1.1 Connecting a Device to the Network
The Control4
®
Composer Pro Network tab lists all devices in the systems with a network connection
and lists network addresses.
Verify the network address for any device that communicates to the Controller using TCP/IP, WiFi,
ZigBee, ZigBee Pro or any other device that uses a network address.
To connect network devices:
1. Start Composer and connect to a Director.
2. Click Connections > Network tab.
3. Select the device, and then click Identify for the wizard to open.
4. Follow the on-screen instructions to identify each device as indicated. After identifying the network
connection, the device’s address appears.
5. Use the Network tab to identify devices to the Control4 system that use a network address.
There are two (2) places to verify network connections: the Network tab and the Tools menu.