System information

Release 11 SP2 Build 11.2.053 13
BIOS Details
NOTE: BIOS versions include D50D (3.0B), X50m (2.0C), and Z50D/S (3.0B).
Steps to update the BIOS manually:
1. Unzip the BIOS file and copy the extracted folder onto a bootable USB flash drive.
2. Boot the device from the USB flash drive (most C class and R class device users can
also use the one time boot menu - press and hold the P key, select the USB drive
option that is displayed for your BIOS version, and then press Enter). For details on
booting your device from a USB flash drive, see your device documentation.
3. Change directory to the respective BIOS folder.
4. Run the f.bat file, and when completed, reboot the device.
5. Enter the BIOS setup again and press the F9 key to load default configurations.
6. Enable ACPI P-state in Power management.
7. (Optional) Restore the boot order accordingly.
8. Press the F10 key to save changes and exit.
Steps to update NON-NIST BIOS to NIST BIOS manually:
1. Copy the base 4.0A and F4.0AN NIST BIOS to a bootable USB device.
2. Be sure the client is shut down and disconnected from any network. Insert the
configured USB key into a thin client USB 2.0 port.
3. Power on the Non-NIST BIOS (3.0B) client and during boot, press and hold the
Delete key.
4. Enter the password Fireport (this is case sensitive) and press Enter to enter the
BIOS.
5. Select the Advanced tab. Using the down arrow key, select the Boot from USB
option and press Enter.
6. Select the Enabled option and press Enter.
7. Press the F10 key to save and exit, and during boot, press and hold the P key.
8. Select the USB Device option and press Enter to enter the DOS mode.
9. Go to the directory IEEPROG, and then type command ieeprog /l.
10.Check the Security Key and Wyse Flag box, and then type the command ieeprog /
F 0003.
11.Then update the base BIOS 4.0A.
12.Go to BIOS setup. Select the Advanced tab. Using the down arrow key, select the
Boot from USB option and press Enter.
13.Select the Enabled option and press Enter.
14.Press the F10 key to save and exit, and during boot, press and hold the P key.
15.Then update the NIST BIOS 4.0AN.
NOTES:
• Non-NIST BIOS can be updated to the NIST BIOS but the reverse is not possible.
• NIST BIOS can be upgraded with another NIST BIOS version but a down-grade is
not possible.