User guide

2.8 Power-saving Modes

Set Max. Power Saving to On.

After the PC has turned on, the monitor will automatically turn itself on

when it receives a video signal from the PC . However, the monitor will

not automatically power on, even if it receives a video signal, if it was

powered off by the button.

You cannot receive an incoming call in maximum power-saving mode; the

monitor will not automatically power on.

Refer to Windows Help for details about how to conﬁgure power saving set-

tings for your PC.

Standby Mode

In VC mode, you can set the monitor to automatically switch to standby mode

after the remote control has been left idle for a speciﬁed time:

If the monitor is in PC or DVI mode, press to switch to VC mode.

Press to open the Setup screen.

Select an interval for activating Standby mode. Each interval is a mul-

tiple of 10 minutes from 10 to 60 minutes.

If Standby is set to 10 minutes, the monitor will automatically turn off

and switch to standby mode after the remote control has been left idle

for 10 minutes.

To turn on the monitor again, press any button other than .

The monitor will automatically turn on when a call is received during

standby mode. However, the monitor will not automatically power on,

even if it receives a call, if it was powered off by the button.

◀ 15 ▶