Specifications

7. Test Mode
10 SAMSUNG ELECTRONICS CO., LTD
1. Driving Compartment Test Mode
A. Hold down “Temp” and ”Delay Start” keys simultaneously and then press POWER S/W on.
(Display shows “tESt”)
Hold down “Delay Start” and “Temp” keys simultanesously (each processing for 0.3sec) and then
press POWER S/W on.
B. The driving compartment can be tested when you press START/PAUSE key right after entering
into the intial stage of the TEST MODE.
• Driving Compartment Test
Pre-wash VALVE ON(0.3sec) ➔ OFF(0.3sec) ➔ Main wash(0.3sec) ➔ OFF(0.3sec) ➔
Rinse VALVE ON(0.3sec) ➔ OFF(0.3sec) ➔ Spin MOTOR ON(0.3sec) ➔ OFF(0.3sec) ➔
MOTOR RELAY1 ON(0.3sec) ➔ OFF(0.3sec) ➔ MOTOR RELAY2(0.3sec) ➔ OFF(0.3sec) ➔
MOTOR RELAY2 ON(0.3sec) ➔ OFF(0.3sec) ➔ HEATER RELAY ON(0.3sec) ➔ OFF(0.3sec) ➔
DOOR OPEN (Function continues when door is closed)
2. THERMISTOR TEST MODE
A. Hold down “Delay Star” and Function keys simultaneously and then press POWER S/W on.
B. Display shows the current THERMISTOR data index in celsius degrees.
3. UNBALANCE TEST MODE
A. Hold down “Temp” and “Spin” keys simlitaneously and then press POWER S/W ON.
B. Display shows ”Unbt” and the machine starts to sense the degree of deviation of the laundry
balance for 9 minutes via 1st and 2nd setection.
C. After selecting the deviation degree of the laundry balance, it displays the data(in hex value) for
10 seconds.
4. LOAD AMOUNT SENSING TEST MODE
A. Hold down ”Door Open” key and then press POWER S/W ON.
B. Display shows ‘0000’ and the machine starts to measure the dropping time from 600 RPM to 100
RPM for 1minute.
C. After setecting the amount of load, it display the data in a hex value.
o
C
rpm
Min
Fuzzy control
Temp Spin Delay Start Function
Door open
Spin
Check
Remaining Time
Delay Start
Rinse
Wash
Pre-wash
Eco
Speedy
Wool
Delicate
Synthetic
Cotton
12:00
TEMP 5 10 15 20 25 30 35 40 45
DATA 5 10 15 20 25 30 35 40 45
TEMP 50 55 60 65 70 75 80 85 90
DATA 50 55 60 65 70 75 80 85 90