User guide

COLOR CCD CAMERA User Guide
12
COLOR CCD CAMERA User Guide
13
1. Please take off the CCD protection cap
and C-mount adapter.
C-mountadapter
CCDprotectioncap
CS-mountadapter
When using a CS-Mount lens
• Pleaseusethespecifiedlensconnectionpartsasshowninthepicturebelow.
The use of the wrong sized parts may cause damage to the inside of the camera or
result in poor fitting.
• Useofalenswhichistooheavyaffectsthebalanceofthe
cameraand may cause a malfunction.  Please use a lens
thatweighslessthan450g.
• PleaseselectAvmodeifpossiblewhenadjustingthe
automaticlightcontrol(ALC)ofanautolens.UseofPKmode
may cause hunting.
Notes
C-mountlens:10mmorless
CS-mountlens:5mmorless
2. Please attach the CS-mount lens to the
camera by screwing it in clockwise.
Installation
When using a C-Mount lens
3. Remove the cover of the auto iris lens connector plug and solder the lens cable to the
connector pin of the plug.
No.3Pin
No.1Pin
Connector
Lenscable
No.4Pin
No.2Pin
5. Please insert the connection plug that is connected to
the auto iris lens cable into the auto lens connector,
which is located on the side of the camera.
Please take off the CCD protection cap and attach the C-Mount lens to
the camera by screwing it in clockwise.
C-mountadapter
When Using Auto Iris Lens
1. Strip the insulation of the auto iris lens
cable 8mm from the end.
2. Strip the insulation of the core of the auto
iris lens cable to expose a 2mm length.
8mm
2mm
LENS
Pin No. DC VIDEO
No.1 Pin Damping - Red (power)
No.2 Pin Damping + NC
No.3 Pin Drive + White (video signal)
No.4 Pin Drive - Black (GND)
4. Please replace the auto iris lens connection plug cover and take off the CCD protection
cap, and then attach the auto iris lens to the camera by screwing it in clockwise.