Specifications

OfficeServ 100 General Description Guide/Ed.00

4.1.1.29 Data Security

Single line extensions used with modems and facsimile machines can be programmed so

that they will not receive any system-generated tones that would disrupt data transmissions.

In addition, these devices receive DCS C.O. ringing pattern instead of intercom ring pattern.

Devices connected to an SLI card receive a disconnect signal upon termination.

4.1.1.30 Database Printout

A copy of the customer database can be obtained by using PCMMC. This information can

be directed to a printer or the PC screen and may be done either on-site or remotely.

A complete database or specific data blocks may be obtained.

4.1.1.31 DECT Service

The OfficeServ 100 system provides DECT cordless communications in a single office or

throughout a large commercial or industrial complex. To implement this service, you need

BSI card, DB(Daughter Board) card and DECT handsets. Users of this service meet

improved overall efficiency, since staff can be reached or make calls wherever they are.

4.1.1.32 DNIS (Dialed Number Identification Service)

When DNIS service is provided on an incoming trunk the OfficeServ 100 can route calls

based on the numbers received.

4.1.1.33 Direct in Lines

Outside lines may be programmed to bypass the operator(s) and ring directly at any station

or group of stations.

4.1.1.34 DID(Direct Inward Dialing) E1/Copper

The term DID or DID refers to four types of digit steered inbound call handling. These are

DID, Both Way DID, Dialed Number Identification service(DNIS and Direct Dial In(DDI).

The OfficeServ 100 supports all four types as described below.

DID is an inbound only service where multiple telephone numbers are assigned, usually in

blocks of twenty, to a single circuit or small group of circuits. These circuits can be single

pair analog circuits that will terminate on a DID card. The OfficeServ 100 DID card

supports up to four circuits. In addition the DID circuit can be a channel on a digital E1

service terminating on an OfficeServ 100 TEPRI card.

Both way DID is a service that combines DID service with normal outbound local

telephone service. This service is provided over E & M tie line circuits. These E & M tie

line circuits can terminate on either the iDCS E & M card or on a channel of a digital E1

circuit on an iDCS TEPRI card.