manual de utilizador(Windows 7)

20_ operating the cleaner
INSTALLING THE VACUUM CLEANING ROBOT
Installation order
1. Turning the Power Switch on or o
To use the robotic vacuum cleaner, you must turn on the Power Switch
at the bottom of the main unit.
2. Installing the Charger
To charge the robotic vacuum cleaner, you must first install the charger.
Since the battery is discharged when the product is purchased, you
must fully charge the battery before use.
3. Charging the Battery
You should charge the battery completely before using the robotic
vacuum cleaner.
4. Installing the VIRTUAL GUARD
You can confine the robotic vacuum cleaner to a particular section by
using Fence (virtual wall) mode.
5. Installing the air freshener
Please install the air freshener before using the robotic vacuum cleaner.
If the air freshener is installed, the robotic vacuum cleaner will give o a
pleasant fragrance.
Turning the Power Switch on or o
To use the robotic vacuum cleaner, you must turn the Power
Switch on.
If you turn the Power Switch o, all settings will be reset.
1. Turn over the main unit and turn the Power Switch on.
- If the icons are not turned on, it indicates that the battery charge
is depleted. In this case, dock the robotic vacuum cleaner to
the charger station after turning the Power Switch on.
- Note that turning the Power Switch o will reset all settings.
❈
When no key is pressed for approximately 10 minutes when
the power is on, the power is automatically turned o to save
battery power. In this case, to use this robotic vacuum cleaner
again, please push the “Power” button or “Start/Stop” button.
If the Power Switch is turned o, the robotic vacuum cleaner will not be charged even if it is
docked with the charger station.
CAUTION
operating the cleaner