User Manual

English 27
Installation
STEP 2 Flooring
• The surface to install the refrigerator
must support a fully loaded refrigerator,
or approximately 90 kg.
• To protect the oor, put a large piece
of cardboard on each leg of the
refrigerator.
• Once the refrigerator is in its nal
position, do not move it unless
necessary to protect the oor. If you
have to, use a thick paper or cloth such
as old carpets along the movement path.
STEP 3 Adjust the levelling legs
Level the refrigerator by manually
adjusting the levelling legs. Turn the
levelling legs clockwise to lower the
position, or turn counter clockwise to raise.
For safety reasons, adjust the front side a
little higher than the rear side.
A
Leave the legs at least (A) mm from the
oor as shown.
• (A) 39 mm for RT18*
• (A) 43 mm for RT21*
Untitled-7 27 2017-03-15  4:09:50