Specifications

Memorlzlnl

Your PDP can memorize and store all of the available channels for both "off-air"

(antenna) and cable channels. After the available channels are memorized, use the

CH/_. and CH v buttons to scan through the channels. This eliminates the need to

change channels by entering the channel digits. There are three steps for memorizing

channels: selecting a broadcast source, memorizing the channels (automatic) and

adding and deleting channels (manual).

SelectingtheVideoSignal-source

Before your television can begin memorizing the available channels, you must specify the type of signal

source that is connected to the PDP (i.e., an antenna or a cable system).

Pressthe MENU button. Pressthe • or • button to

select "Channel", then press the ENTER button.

Pressthe ENTER button to select "Air/CATV".

Press the • or • button to select "Air", "STD",

"HRC" or "IRC'.

• If you are connected to an antenna, leave "Air"

displayed. If you connected cable, press the

• or • button to the display the type of cable

system: "STD', "HRC" or "IRC'.

(If you are not sure which type of cable system you

have, contact your cable company).

Pressthe MENU button to exit.

• STD, HRC and IRC identify various types of cable TV systems. Contact your local cable company to

identify the type of cable system that exists in your particular area. At this point the signal source

has been selected. Proceed to "Storing Channels in Memory" (Next page).