Specifications
Table Of Contents
- SP-M200 SP-M220 SP-M250
- Table Of Contents
- 1 Major Safety Precautions
- 2 Installation and Connection
- 2-1 Package Contents
- 2-2 Installing the Projector
- 2-3 Leveling with Adjustable Feet
- 2-4 Zoom and Focus Adjustment
- 2-5 Screen Size and Projection Distance
- 2-6 Lamp Replacement
- 2-7 Rear Side
- 2-8 Supported Display Modes
- 2-9 Connecting the Power
- 2-10 Connecting with a PC and Setting up the PC
- 2-11 Connecting a PC using an HDMI/DVI cable
- 2-12 Connecting an HDMI-Compatible Device
- 2-13 Connecting an AV device using a D-Sub cable
- 2-14 Connecting an AV device with component output
- 2-15 Connecting using a Video cable
- 2-16 Connecting an External Speaker
- 2-17 Kensington Lock slot
- 3 Using
- 4 Troubleshooting
- 5 More Information
Installation and Connection 2-6
3. To remove the lamp, hold and then pull the lamp handle as shown in the figure below.
Install a new lamp in the reverse order of removal.
Replacing and Cleaning the Filter
Precautions when replacing the projector filter:
• The filter is on the side of the projector.
• Turn off the power of the projector, and then disconnect the power cord after the projector has cooled sufficiently.
Otherwise, its parts may be damaged due to internal heat.
• When you replace the filter, you may release some dust.
• For inquiries on replacement filter purchase, please see 'Contact SAMSUNG WORLDWIDE' in Chapter 5.
To replace or clean the filter, follow these steps:
1. Turn off the power of the projector, and then disconnect the power cord after the projector has cooled sufficiently.
2. Open the filter cover.
3. Replace or clean the filter.
• When cleaning the filter, use a small vacuum cleaner designed for computers and small electronics products, or wash it under
running water.
• After washing the filter under running water, make sure to dry it completely. The moisture may cause the filter to corrode.
• If dust cannot be separated from the filter or the filter is torn, it must be replaced.
• After cleaning or replacing the filter, run <Reset> -> <Reset Filter Time> in the <Setup> menu.
Ventilation openings
For the location of the ventilation openings, see the picture below:
• Do not block the ventilation openings. Blocking the ventilation openings can cause your projector to overheat and may cause
it to fail.
Downloaded From projector-manual.com Samsung Manuals