PCS Vision Smart Device User's Guide

Section 2A: Your Sprint PCS Phone - The Basics 19
Using the Travel Charger/Desktop Charger
To use the Travel Charger/Desktop Charger:
1. Insert the phone into the Desktop Charger cradle being careful
to insert the power/data interface connector.
2. Press down and back until the phone is locked into place.
3. Plug in the Travel Charger connector to the back of the
Desktop Charger and plug the other end into a standard wall
outlet receptacle.
When charging the battery, a red light is displayed on the front of
the Desktop Charger. A charging icon is also displayed in the upper
right corner of the screen on your phone’s inside or outside LCD
screen.
When the battery is completely charged, a green light is displayed
on the front of the Desktop Charger.
It takes approximately 4 hours to fully recharge a completely
rundown standard battery and 6 hours for an extended battery.
Performing an ActiveSync Operation
The ActiveSync application is responsible for keeping your SP-i600
and desktop or laptop machine synchronized. By keeping both your
devices synchronized, you minimize the risk of losing any
information. The ActiveSync operation is done using a partnership
that is created between the SP-i600 and the computer. This
partnership is unique to the device and cannot be used with any
other ActiveSync enabled devices.
For more information regarding the ActiveSync operation and how
to set up your SP-i600 to connect to the desktop or laptop machine,
see the Guide to Activating and Using Your Phone included with your
device.