User Guide

OSD menu
5
SOURCE TRIGGER
Press OK KEY to enter the sub-menu
AUDIO CONTROL
Press OK KEY to enter the sub-menu
FACTORY RESET
Press OK KEY to reset PVM Monitor to factory default setting.
VOLUME – Adjust the PVM Monitor volume.
MUTE – Select Audio MUTE ON/OFF.
EXIT – Press OK KEY to return to the main
menu.
1. Press / KEY to select an icon
2. Press / KEY to selection and adjust the
value
3. Press EXIT KEY to return
TRIGGER – Select trigger OFF/MOTION
EVENT SOURCE – Select Motion event
source HDMI/VGA
EXIT – Press OK KEY to return to the main
menu
FW. UPDATE (USB) – Plug USB with update
FW then select this icon to update PVM FW
1. Press / KEY to select an icon
3. Press / KEY to selection and adjust the
value
4. Press EXIT KEY to return
GENERAL
BEFORE YOU BEGIN
Read these instructions before installing or operating this product.
Note: This installation should be made by a qualified service person and should conform to local codes.
Intended use
This manual provides installation and operation information. To use this document, you must have the
following minimum qualifications:
A basic knowledge of CCTV systems and components
A basic knowledge of electrical wiring and low-voltage electrical connections
Only use this product for its designated purpose; refer to the product specification and
user documentation.
Customer Support
For assistance in installing, operating, maintaining and troubleshooting this product refer to this
document and any other documentation provided.
Improper use of this equipment can cause severe bodily injury or equipment damage.
To reduce the risk of fire or electric shock, do not insert any metallic objects through
the ventilation grills or other openings on the equipment.
Improper use of this equipment can cause equipment damage.
Note: Notes contain important information about a product or procedure.
All lead-free products offered by the company comply with the requirements of the European
law on the Restriction of Hazardous Substances (RoHS) directive: 2011/65/EU, which means
our manufacture processes and products are strictly “lead-free” and without the hazardous
substances cited in the directive.
The crossed-out wheeled bin mark symbolizes that within the European Union the product
must be collected separately at the product end-of-life. This applies to your product and any
peripherals marked with this symbol. Do not dispose of these products as unsorted
municipal waste.
Conventions Used in this Manual
* WARNING:
** Caution:
* This symbol indicates electrical warnings and cautions.
** This symbol indicates general warnings and cautions.
Boldface or button icons highlight command entries. The following WARNING, CAUTION and Note
statements identify potential hazards that can occur if the equipment is not handled properly:
!
16
WARNINGS AND CAUTIONS:
This is a Class A product. In a domestic environment this product may cause radio
interference in which case the user may be required to take adequate measures.
WARNING: