User Guide

general
SCOPE
SAFETY PRECAUTIONS
This document is used to define the performance of the LCD Public View Monitor (PVM) series. The system
supports HDMI and PC inputs, as well as from the built-in camera. The On Screen Display (OSD) menu
makes the system easy to operate.
1.
2.
Do not modify the three-prong grounding type monitor power plug in any way.
Operate this unit only from the type of power source indicated on the label.
3.
Do not block or cover ventilation openings on the back or bottom of the monitor cabinet.
4.
Do not place this monitor near a radiator or heating vent.
5.
Do not push objects of any kind through cabinet openings. This may result in fire or electrical shock.
6.
Before adding attachments always ask a service technician to perform routine safety tests to determine
that equipment is in safe operating condition. Ground potential tests should be part of the routine safety
check made by the service technician.
7.
Do not place monitor on an unstable cart, stand, or shelf where it may fall and injure personnel or
damage equipment.
8.
Route power cords so that they cannot be walked upon or tripped over. Do not allow anything to rest on
the power cord.
9.
Do not install monitor in wet areas, or where it may be exposed to rain or water. Do not spill liquid of any
kind on the unit.
10.
Unplug the power cord from the unit before cleaning the display. Use only a damp cloth. Do not use
alcohol, spirits, or ammonia to clean the display. DO NOT ATTEMPT TO CLEAN THE INTERIOR OF
THIS UNIT- THIS ACTION MUST BE PERFORMED BY THE SERVICE TECHNICIAN AS REQUIRED
DURING NORMAL MAINTENANCE.
11.
Refer all servicing to qualified service personnel. REMOVAL OF BACK COVER BY UNAUTHORIZED
PERSONNEL MAY EXPOSE THE USER TO DANGEROUS VOLTAGES OR OTHER HAZARDS.
12.
Unplug the unit immediately and notify the service technician.
A.
If liquid has been spilled into the display or the display has been exposed to rain or water.
B.
If the unit has been dropped or the cabinet damaged.
C.
If fuses continue to blow.
D.
If the power cord is damaged or frayed.
E.
If a distinct change from normal operation is apparent.
When replacement parts are required, be sure that the service technician uses components specified by the
manufacturer which have the same characteristics as the original parts. UNAUTHORIZED SUBSTITUTIONS
MAY RESULT IN FIRE, ELECTRICAL SHOCK OR OTHER HAZARDS.
Upon completion of any service or repairs, ask the technician to perform safety checks to determine that the
equipment is in safe operating condition.
WARNING: SERIOUS SHOCK HAZARDS EXIST WITHIN THE COVERS OF THIS MONITOR. DO NOT
OPEN THE COVERS UNDER ANY CIRCUMSTANCES,
THERE ARE NO USER SERVICEABLE COMPONENTS INSIDE
17
BANNER POSITION – Select Banner Position TOP /
BOTTOM
BANNER ACTION – Select Banner Action OFF/
Blinking/Switching
INTERVAL DWELL – Set Banner on Dwell Timer 1~5 sec.
INTERVAL DELAY – Set Banner off Time 1~5 sec.
SELECT BANNER 1 – Select Banner 1 Type
SELECT BANNER 2 – Select Banner 2 Type
EXIT – Press OK KEY to return to the main menu
1. Press / KEY to select an icon
2. Press / KEY to selection and adjust the
value
3. Press EXIT KEY button to return
OSD MENU
BANNER FUNCTION
OSD menu
4
ABC RETAIL
XYC RETAIL