User Guide

POWER KEY: Monitor Power On/Off.
MUTE KEY: Mute the Audio.
SOURCE KEY: Select input signal.
KEY: OSD scrolling the cursor to desired function.
OK KEY: Confirmation key during the OSD operation
EXIT KEY: Exit the OSD menu
MENU KEY: Monitor OSD control
CAMERA KEY: Select camera mode
KEY LOCK: Monitor KEY LOCK
VGA: Select VGA input
HDMI: Select HDMI input
SWAP : Swap camera video & HDMI/PIP input source, (PIP
Model only)
: Select PIP size & PIP position and Sequential Display Dwell
time setting.(PIP Model only)
MODE : Select MODE 1 (One view mode), MODE 2 (PIP mode),
MODE 3 (POP mode A), MODE 4 (POP mode B) & Sequential
Display. (PIP Model only).
ACCESSORIES
1. Remote Control x 1
2. DC Terminal x 1
3. AAA battery x 2
4. User’s Manual x 1
5. M4 x10mm Bolts x 5
6. Self-adhesive wire tiedown x 1
7. Screw M3 x 6mm x 1
CONTROLS & INDICATORS
controls & indicators
11
Notes:
The remote control requires 2xAAA batteries. Ensure batteries are inserted in the correct polarity
according to the + and – symbols in the battery compartment.
To avoid damage from possible battery leakage, remove the batteries if you do not plan to use the
remote control handset for an extended period of time.
Batteries should last more than 2 years with normal use.
BOTTOM PANEL VIEW (PIP MODEL ONLY) REMOTE CONTROL
(A) Light sensor: (measures ambient light for auto adjust settings)
(B) IR Receiver: (for remote control)
(C) LED: ON - GREEN/FLASH GREEN / FLASH RED. (Programmable from
OSD menu);
OFF - RED
LED INDICATION
A B C
All of the accessories listed below are included with the PVM.
10
1. POWER LED : This red LED illuminates when power on
2. OUTPUT LED : This red LED illuminates when the PIP HDMI output
3. N1 LED : This red LED illuminates when the Camera video is selected as main
image
4. N2 LED : This red LED iluminates when the HDMI/PIP is selected as main
image
5. SOURCE : Press the button to select the input source as main
6. MODE : Press the button to select display mode
7. POSITION : Press the button to select the position of sub image when in PIP
mode
8. SIZE : Press the button to select the size of sub image when in PIP mode
7. RESOLUTION : Press the button to select the output resolution