User Guide

VIVID MODE – Select Vivid mode
BRIGHTNESS – Adjust the brightness value
CONTRAST – Adjust the contrast value
SHARPNESS – Adjust the sharpness
SATURATION – Adjust the saturation
NR – Set Noise Reduction level OFF/LOW/MIDDLE/HIGH
DLC – Set Dynamic Luminance Control ON/OFF
EXIT – Press OK KEY to return to the main menu
1. Press / KEY to select an icon
2. Press / KEY to selection and adjust the
value
3. Press EXIT KEY button to return
OSD menu controls & indicators
HOT KEY
MAIN MENU
Press MENU KEY to enter the sub-menu
MAIN ADJUST
Press OK KEY to enter the sub-menu
9
Press / KEY to select an icon, then press
OK KEY to confirm the selection.
VOLUME : Press / KEY to
adjust the volume.
KEY LOCK : Press
remote control KEY
LOCK to enable this
function.
KEY UN-LOCK : Press
remote control KEY
LOCK again to disable
this function.
Main Adjust
Color Adjust
Scan Setting
Image Adjust
Information
Language
Setup Menu
Factory Reset
Audio Control
Exit
Press the buttons to scrolling the cursor to desired function.
Press the buttons to increase the value of selected function in sub OSD menu.
Press the buttons to scrolling the cursor to desired function.
Press the buttons to decrease the value of selected function in sub OSD menu.
(C) “ ” Down button
CONTROLS & INDICATORS
(A) “ ” Source button
Press the button to show source menu. Select VGA, HDMI, and CAMERA input.
Press the button to show the OSD main menu.
As a confirmation key during the OSD operation.
(D) “ ” Menu button
Press the button to turn ON or turn OFF the monitor.
(E) “ ” Power button
CONTROL BUTTON (ON THE BACK)
(B) “ ” Up button
12
A
B
C
D
E
Camera Reset
Access Door
Camera SD Card
Access Door