Owner's Manual

STACKING KIT INSTALLATION INSTRUCTIONS (WASHER & DRYER ONLY)
STEP 6 Lift and position dryer
into the position on the
washer shown above, slide
dryer backwards to make
contact with rear brackets.
STOP
HERE
CAUTION : To prevent noise, check the followings.
• Make sure the washer is level.
• Make sure the dryer’s leveling legs are tightened up.
(Stacking kit: SKK-7*, SKK-8*, for 27” models)
STEP 7 Align rear brackets with
mounting holes on the
rear of dryer as shown
above.
STEP 8 LOOSELY assemble rear
brackets to the back of
the dryer using two (2)
Screws- Phillips Pan Head
(6006-001174) for each
rear bracket as shown
above.
Extra screws may be
included with this kit.
STEP 9 Tighten screws on the
dryer side of the rear
bracket.
WARNING : Additional gas hook-up components are
required for gas dryer.
STEP 10 Tighten screws on the
washer side of the rear
bracket.
* DO NOT REVERSE THE ORDER OF
STEPS 9 & 10.
STEP 11 Stacked Unit is now ready
to be installed. Refer
to detailed installation
instructions packed with
products.
Stacking kit components
Stacking Support Guides (2) SKK-7*, SKK-8* - DC61-04159A
Rear Bracket (2) (WF5*K**, WF4*H**,
WF4*K**, WF4*M**, WF4*N**, WF18H**,
WF20H**, WF20M**, WF22H**,
WF22K**, WF15K**, WF16J65**)
SKK-7*, SKK-8* - DC61-04160A
Rear Bracket (2) (WF5*R**, WF4*R**)
SKK-7*, SKK-8* - DC61-04955A
Stacking Support Guides (2)
SKK-BB - DC61-01480B
Rear Bracket (2) (WF56H**)
SKK-BB - DC61-03846A
Screws-Hex Head (4)
SKK-BB - 6009-001476
SKK-7*, SKK-8* - 6002-001431
Screws Phillips-Pan Head (8) - 6006-001174
Washer (4) - DC60-00044A
Rear Bracket
(WF5*K**, WF4*H**,
WF4*K**, WF4*M**,
WF4*N**, WF18H**,
WF20H**, WF20M**,
WF22H**, WF22K**,
WF15K**, WF16J65**)
Rear Bracket
(WF56H**)
Rear Bracket
(WF5*R**, WF4*R**)
Screw-Hex Head
SKK-BB (M5, L10)
SKK-7*, SKK-8* (M5, L16)
Screw Phillips-Pan
Head
(M4, L12)
Washer (ID5, OD10)
Stacking Support Guide
StakingKit_DC68-01052R-09_EN.indd 2 2019-03-08  2:27:51