User`s manual

COLOR CCD CAMERA User’s Manual (SID-370)
12
COLOR CCD CAMERA User’s Manual (SID-370)
13
180˚
90˚
83˚
0˚
FixedBracketFixation
Screw
Installation
Adjust the panning and tilting, rotating while watching the monitor
Connect the VIDEO-OUT jack to the VIDEO-IN jack of monitor.
Connecting Monitor
CCTVCamera
CCTVCamera
CCTVCamera
Monitor
• As the connecting method varies with the instruments, refer to the manual supplied with the
instrument.
• Only connect the cable when the power is turned off.
• Set the 75Ω / Hi-Z selection switch as shown below if you have an intermediate device.
Connect the adaptor to the power input connector as shown in the figure below. The
recommended adaptor specification for SID-370N/P is DC 12V / 500mA.
Connecting to Power
Connection
----PowerInputTerminal
•Whenadjustthetiltangle,keeptheTiltlimitlineontheRotationCoverangledorlowerthan
theWideAdjustlimitpositionontheRotationGuide(0°~75°).IftheangleoftheRotationCover
overtheTiltlimitline(76°~83°),thecamerascreenbecomesmaskedbythedomecover.
(Exception:At4xZoom,thecamerascreenisnotmaskedbythedomecovereveniftheangle
oftheRotationCovergoesovertheTiltlimitline.)
Notes
WideAdjustlimitposition
TiltLimitLine
1) You can adjust camera to any direction by using Pan, Tilt, Rotate mechanism.
 •AdjustingthepanninganglebymovingtheRotateCover.RotateCoversmovesby180toeachside
directionand380onthewhole.
 •AdjustingtheTiltinganglebymovingtheRotateCover.RotateCoversmovesby83angle.
2) Methods of adjustment
 •Thecaseofwallinstallation

1
Aftermountingthe cameraona wall,loosenthe FixedBracket fixationscrews onthe camera
thenfacetheRotationCovertothedesiredmonitoringdirection.

2
AndtheadjustthetiltingandpanninganglebymovingtheRotateCover.

3
Oncethecoverisadjustedtothedesiredmonitoringdirection,fastentheFixedbracketfixation
screws on the camera.
 •Thecaseofceilinginstallation

1
Afterattachingthecameraonaceilingarea,loosentheFixedBracketFixationscrewsandthen
adjusttheRotationCovertothedesiredmonitoringdirection.

2
Toadjustthetiltangle,refertothe"Notes"inPage12andadjustthehorizontalangleoftheRotation
Cover not to mask the camera screen.

3
Oncethecoverisadjustedtothedesiredmonitoringdirection,fastentheFixedBracketfixationscrews.