User`s manual

COLOR CCD CAMERA User’s Manual (SID-370)
10
COLOR CCD CAMERA User’s Manual (SID-370)
11
Latch
[Figure-1]
DomeCover
MainBody
(Camera)
Locking
Direction
Locking
Direction
Unlocking
direction
Unlocking
direction
1) Separate the dome cover by clockwise rotation.
•Theinstallationshouldbedonebyqualifiedservicepersonnelorsysteminstallers.
•Iftheceilingmaterialisnotstrongenoughtoholdtheinstallationscrews,the
cameramayfalloff.Reinforcetheceilingasneeded.
Notes
* To install the dome cover on the camera body, turn the latches
in locking direction as shown in the figure 1.
Installation
Installation
When installing on a adapter plate
Unlocking
direction
M4tapping
screw (provided)
DomeCover
CAMERA
Locking
direction
adapter plate
Anarrowforinstalling
directioans
[Figure-1]
Locking
direction
Bracket pin
Unlocking
direction
•Facetheinstallationguidearrow(F)ontheadapterplatetothemonitoringdirection,
and then secure the adapter plate with the screws.
Notes
1) Locate the enclosed adapter plate on the desired
ceiling area then secure it with the enclosed M4
tapping screws.
2) When attaching the camera to the adapter plate ,
face the front mark(F) on the bottom of the camera to
the installation guide arrow(F) on the adapter plate as
shown in [Picture-1) below. Insert the bracket pins
into the attaching grooves on the bottom of the
camera then turn them clockwise to hold the camera
with the adapter plate.
3) Before securing the camera to the adapter plate, pass
the power and BNC cables through the adapter plate
to the desired location.(To keep the cables sidewise,
pass them through the adapter plate into the ceiling.)
4) Once the camera is adjusted and installed on the
desired area, turn the dome cover clockwise to secure
the camera to the adapter plate.