User`s manual

COLOR CCD CAMERA User’s Manual (SID-370)
34
COLOR CCD CAMERA User’s Manual (SID-370)
35
• CAM ID : Determines the camera's identification number
(between 0 and 255).
• Protocol : Select the communication PROTOCOL. (STW/PELCO-D/PELCO-P/
BOSCH/HONEYWELL/VICON/AD/SEC/PANASONIC)
• BAUD RATE : You can select 2400/4800/9600/19200/38400/57600/115200 bps.
• UART MODE : You can select NONE, EVEN or ODD for the parity bits.
• TERMINATION : Functi on that sets the resistance at the end of RS-485
communications.
1
When the SPECIAL menu screen is displayed, moving up or down direction of
Function Setup Switch so that the arrow indicates ‘COMM ADJ’.
2
Set up the mode moving the 4 direction of Function Setup Switch.
COMM ADJ (Communication Adjustment) :
This function sets up the camera communication
status when controlling the camera through an
external control device.
COMMUNICATION SETUP
▶
PROTOCOL STW
CAM ID 1
BAUD RATE 9600
UART MODE 8-N-1
TERMINATON OFF
RET PKT DISABLE
END
|
|||||||||||||||||||||||||
•WhenDISisoperating,D-ZOOMdoesnotoperate.
Notes
✽ Setting Termination Resistance.
In order to prevent signal reduction, the termination resistance of the 2 end units,
which are the distant paths for camera and controller to be connected on the RS485
interface, should be connected.
As the termination resistance is built in the camera, whether to make the termination
resistance valid or invalid is selected with the TERMINATION.
See the connection diagram for determining to which device the termination
resistance will be connected to.
Set up the termination resistance in the dark products.
The installation distance of the product for the termination resistance setting should
be less than 1.2 Km. (Maximum cable length is 1.2 Km according to the RS-485
standards.)
DIS : The DIS mode can compensate for vibration of the camera.
•WhenusingaVideoAutoIrisLens,ifyousetthelensleveltolow,automaticswitching
betweenColorandBlack&Whitemaynotoccur.
•YoucannotcontroltheDAY/NIGHTmenuwhenAGCintheEXPOSUREmenuis‘OFF’.
Atthistime,theexchangebetweenDAYmodeandNIGHTmodeoperatesaslikeselecting
‘COLOR’mode.
•The OSD key does not work for 3 seconds when switching to Color or B/W,toensure
stable camera operation.
• The camera may focus less well under infrared illumination than under normal illumination.
•Sincethecameramaynotfocusaswellunderinfraredilluminationatnightasitdoes
undernormalillumination,installanExtra-lowDispersionLenstoobtainsharppictures.
•Thebrightnessofilluminationischangeablebyinstalledenvironment.
Notes
SPECIAL SETUP
PRIVACY OFF
DAY/NIGHT COLOR
DIS OFF
COMM ADJ
Operating Your Camera