User manual
COLOR DOME CAMERA SCV-2080
18
COLOR DOME CAMERA SCV-2080
19
$POOFDUJOHUP.POJUPS
Connect the Video Output jack to the VIDEO-IN jack of monitor.
CCTV Camera Monitor
•
As the connecting method varies with the instruments, refer to the manual supplied with the instrument.
•
If necessary, you can connect the monitor to the REMOTE jack on the back of your camera.
• Only connect the cable when the power is turned off.
Connect the adaptor to the power input terminal as shown in the figure below.
Output of the adaptor should be either one of AC 24 V, 1.5 A or DC 12 V, 1.0 A. Note that using
DC 12 V may cause lower heater temperature.
Connecting to Power
---- Power Input Terminal
• As shown in the table above, voltage decreases as the wire gets longer. Therefore use of
an excessively long adaptor output line for connection to the camera may affect the
performance of the camera.
* There may be some deviation in voltage drop depending on the type of wire and the manufacturer.
When the resistance value of copper wire is at [20˚C(68˚F)]
Copper wire size (AWG)
#24(0.22mm
2
) #22(0.33mm
2
) #20(0.52mm
2
) #18(0.83mm
2
)
Resistance (Ω/m)
0.078 0.050 0.030 0.018
Voltage Drop (V/m)
0.028 0.018 0.011 0.006
Installation
Connection
Connection
• Be sure to connect power only after all the installation is complete.
• Note that AC / DC adaptor is not supplied with camera.
• Ground should be connected to the GND terminal.
Notes
4) CORNER MOUNT ADAPTOR (SCX-300KM)
This is an adaptor for WALL MOUNT
ADAPTOR (SCX-300WM) installation on
the corner of wall joint.
3) POLE MOUNT ADAPTOR(SCX-300PM) This
is an adaptor for WALL MOUNT ADAPTOR
(SCX-300WM) installation on a pole whose
diameter is bigger than 80mm.