User Guide

SAMSUNG Proprietary-Contents may change without notice 5-10
Command No. Signal. Name Description
(OP,AB,RB)
81(E3,0,0) T_VOC_PCMLPON_I Play a PCM LOOP BACK.
82(E4,0,0) T_VOC_PCMLPOFF_I Play off a PCM LOOP BACK.
85(E7,0,0) T_SPEAKER_ON_I Turn on the speaker path.
86(E8,0,0) T_SPEAKER_OFF_I Turn off the speaker path.
87(E9,0,0) T_FM_LOOP_TEST_I Play a PCM FM loopback.
88(EA,0,0) T_TRK_ADJ_I3) FM TRK_LO_ADJ control.
89(EB,0,0) T_CD_TRK_ADJ_I3) CDMA TRK_LO_ADJ control.
92(F2,3,0) T_TXRAS_ADJ_I TXRAS adj = TX RAS offset array.
93(F3,3,0) T_RXRAS_ADJ_I RXRAS adj = RX RAS offset array.
94(F4,4,0) T_HW_CHANFLAT_T H/W Channel Flatness.
95(F5,4,0) T_SW_CHANFLAT_T S/W Channel Flatness.
96(F6,3,0) T_CH_FLATNESS_I Set 22dBm Channel Deviation 10 POINT.
97(F7,3,0) T_FM_TX_PWR_I Set FM PWR LEVEL 2~7
1) ==> The AB (Input Argument Byte Number) values of these commands are used only in the manual test. In
automatic test mode, the AB is regarded as 0.
2) ==> You can assign the value for these commands. If the AB value is assigned without argument,
the test is achieved with the value stored in EEPROM.
3) ==> After you get a desired test value by performing these commands, if you want to save the value in
EEPROM, use T-SAVE-VAL-I command to store the test value into the corresponding position.
* OP : Operation Command Number
AB : Input Argument Byte Number
RB : Return Byte Number