Setup Guide Addendum New features and amendments for DS2 models with built-in CDR
Introduction Built-in CD writer This addendum sheet applies to DS2 units with a built-in CDR. The DS2 CD has the following features over the standard DS2: The Digital Sprite 2 CD has a built-in CDR accessible from the front panel. 1. 2. Built-in CD Writer. Onboard mains power supply. Quick Install (Page 5) The rear panel has now changed to: SERIAL 1 The operation of the internal CDR is identical to using the external CDR as described on the Quick Setup Card.
Serial Telemetry (Connecting External Devices – Page 6) PIN 1 – 16 17 21 – 25 Digital Sprite 2 supports a number of dome manufacturers using serial (twisted pair RS-485) telemetry. Serial telemetry requires a twisted pair connect from the dome to the Bus A connection on the Digital Sprite 2. Note: The D-type connectors on the Digital Sprite 2 are no longer used for telemetry.
Note: The Night and Weekend options are only displayed if a corresponding Night and Weekend schedule has been configured in the Schedule menu. Video Storage (Protected%) The total video storage in Gigabytes (GB) is displayed along with the percentage of video storage which is protected (will not be overwritten). Note that the calculations for recording time assume there is no protected video.
Quad sequence DS2A supports a PPP (Point to Point Protocol) connection from the RS-232 serial port 1 or 2. This port allows a US Robotics modem to be connected directly to the D4 for dial-up. Page, Segment PPP address By default the PPP IP address is 172.17.2.2, this can be changed by selecting a different Network IP address. The PPP address cannot be changed directly, but is changed automatically when the TCP/IP address is adjusted.
may be necessary to wait a few minutes for the remaining images to be protected before unprotecting them. Alarm protection Global and Panic alarms can be protected automatically as they are received. Select whether Global, Panic, or Global and Panic alarms are protected. If no alarms are to be protected, select Disabled. Important information regarding Protected Images. There is a percentage indication of the amount of images that are currently protected on the hard disk.
Activity to Enter the time and date you wish to search to. New Operations Playback time Select this option to automatically enter the last playback time and date the user was viewing into the ‘Activity to’ option. Activity search It is possible to search an area of the screen for activity or text at specified times. To search for activity or text: 1. 2. 3. Once the Search Setup screen has been completed, press following screen is displayed.
Copy an event to CDR or external Zip and Jaz Highlight the event to be copied, and press the copy button. The event will be copied to the CDR Archive list. If the ‘Copy destination on the previous page is set to ‘External’, then the images will be copied to an external Zip or Jaz disk. Using the remote control View more activities To view more than a page of activities scroll down to the bottom of the list, the unit will search further back in time and another list of activities will appear.
Rack mounting kit A rack mounting kit is supplied with this product, it is important to use it correctly. The kit comprises of: 4x (Rack mount screws) 2x (Rack mount ears) 2x (Rear supports) Installation Before connecting cables to the back of the unit: 1. 2. 3. 4. Attach the rear supports to the rack. Using the supplied screws, attach the rack mount ears to each side of the unit. Position the unit on the rear supports. Attach the rack mount ears to the front of the rack.
9 MI-A-DS2AC/E1-1 Dedicated Micros, March 2004
