DJ68-00368A(0.5)(EN) 6/16/08 1:41 PM Page 1 Operating Instructions VACUUM CLEANER ❈ Before operating this unit, please read the instructions carefully. ❈ Indoor use only. Register your product at www.samsung.
DJ68-00368A(0.5)(EN) 6/16/08 1:41 PM Page 2 IMPORTANT SAFEGUARDS 1. Read all instructions carefully. Before switching on, make sure that the voltage of your electricity supply is the same as that indicated on the rating plate on the bottom of the cleaner. 2. WARNING : Do not use the vacuum cleaner when rug or floor is wet. Do not use to suck up water. 3. Close supervision is necessary when any appliance is used by or near children. Do not allow the vacuum cleaner to be used as a toy.
DJ68-00368A(0.5)(EN) 6/16/08 1:41 PM Page 3 1 ASSEMBLING THE CLEANER OPTION ▼ *OPTION Features may vary according to model. Refer to 5,6 page. CAUTION Please do not press the button of dust bin handle when carrying machine. For storage, park the floor nozzle.
DJ68-00368A(0.5)(EN) 6/16/08 1:41 PM Page 4 2 OPERATING THE CLEANER 2-1. POWER CORD NOTE When removing the plug from the electrical outlet, grasp the plug, not the cord. Please make sure your cable is fully extended before use. 2-2. POWER CONTROL (INFRARED CONTROL) - HOSE SENDER 1. Vacuum cleaner ON/OFF ( ) Press the ON/OFF button to operate the vacuum cleaner. Press again to stop the vacuum cleaner. 2. Vacuum cleaner MODE (-/+) Press the MODE button repeatedly to select the correct mode.
DJ68-00368A(0.5)(EN) 6/16/08 1:41 PM Page 5 ▼ 2-3. HOW TO USE AND MAINTAIN THE ACCESSORIES Features may vary according to model. PIPE Adjust the length of the telescopic pipe by sliding the length control button located in the center of the telescopic pipe back and forth. To check for blockages, separate the telescopic pipe and adjust to shorten. This allows for easier removal of waste clogging the tube. ACCESSORY Push the accessory on to the end of the hose handle.
DJ68-00368A(0.5)(EN) 6/16/08 1:41 PM Page 6 OPTION ▲ ▲ Carpet Cleaning ▲ ▲ Floor Cleaning Adjust the inlet lever according to the floor surface. Remove waste matter completely if the inlet is blocked. OPTION Vacuum dust in wide area at once Remove waste matter completely if the inlet is blocked. OPTION Frequent vacuuming of hair or pet fur may cause a falling-off of the rotation due to matters tangled around the drum. In this case, clean the drum with care.
DJ68-00368A(0.5)(EN) 6/16/08 1:41 PM Page 7 3 EMPTYING THE DUST BIN 1 2 Once dust reaches the DUST FULL mark, empty the dust bin 4 3 Take the dust bin out by pressing the button. 5 Throw the dust away in the bin. Separate the dust bin cover. 6 After empting the DUST BIN, remove the obstacles like hair, fur on the cap of the DUST BIN. Before use, push the dust bin into the main body of the vacuum cleaner until you hear the "click" sound.
DJ68-00368A(0.5)(EN) 6/16/08 1:41 PM Page 8 4 CLEANING THE DUST PACK 4-1. WHEN TO CLEAN THE DUST PACK - Please, check the dust bin and dust pack if suction is noticeably reduced or the filter check indicator lamp turns on after empting the dust bin. The lamp will illuminate to signal when suction is reduced. If the light comes on, please clean the DUST BIN as shown. 4-2.
DJ68-00368A(0.5)(EN) 6/16/08 1:41 PM Page 9 4-4. CLEANING THE DUST PACK 1 3 2 Remove the dust bin and dust pack as shown. 4 Remove the fixed frame of the dust pack cover. Remove the sponge and filter from the dust pack. 5 Wash the sponge and the filter of the dust pack with water. 7 6 Let the sponge and filter dry in the shade for more than 12 hours. Put the sponge and filter into the dust pack. 8 Before reassembly, align the dust pack cover and dust pack correctly.
DJ68-00368A(0.5)(EN) 6/16/08 1:41 PM Page 10 5 CLEANING THE MOTOR PROTECTION FILTER Remove the motor protection filter from the vacuum cleaner. Shake and tap the dust from it and put back in machine. Take out both the dust bin and the dust pack. 6 CLEANING THE OUTLET FILTER 1 2 Remove the dust bin. 3 Pull out the HEPA Filter as shown. 4 Dust the HEPA filter. Put the HEPA filter into the main body until you hear a ‘click’ sound.
DJ68-00368A(0.5)(EN) 6/16/08 1:41 PM Page 11 7 CHANGE THE BATTERY(OPTIONAL) BATTERY TYPE : AAA Size NOTE 1. When the vacuum cleaner does not work, replace the batteries. If the problem persists, please contact our authorized dealer. 2. Use 2 batteries of size AAA. 1. Never disassemble or recharge the batteries. WARNING 2. Never heat up the batteries or throw them into fire. 3. Do not reverse (+),(-) poles. 4. Dispose of the batteries properly. - IF YOU HAVE A PROBLEM PROBLEM Motor does not start.
DJ68-00368A(0.5)(EN) 6/16/08 1:41 PM Page 12 DJ68-00368A REV(0.
