User manual

setting up _07
01 SETTING UP
SETTING UP THE REFRIGERATOR
DOORS
If your entrance won’t allow the refrigerator to pass
easily through it, you can remove the doors.
Removing the Freezer Doors
Disassemble the hinge cover ( 1. 1 ) with a
screwdriver while the door is open and then
close the door, and then disconnect the wires
by gently pulling them apart ( 2 ).
Removing the FIXER HINGE ,and next take off 2.
the upper hinge. Be careful that the door does
not fall on you as you are removing it.
Be sure to keep track of all parts you are
removing.
Next, remove the door from the lower hinge ( 3. 3 )
by carefully lifting the door straight up ( 4 ).
Reattaching the Freezer Doors
To reattach the freezer doors, replace parts in
reverse order.
Removing the Fridge Door
Disassemble the hinge cover ( 1. 1 ) with a
screwdriver while the door is open and then
close the door.
Removing the FIXER HINGE ,and next take off 2.
the upper hinge. Be careful that the door does
not fall on you as you are removing it.
Be sure to keep track of all parts you are
removing.
Remove the door from the lower hinge ( 3. 2 ) by
lifting the door straight up ( 3 ).
Reattaching the Fridge Door
To reattach the fridge doors, replace parts
in reverse order.
LEVELLING THE REFRIGERATOR
If you install the refrigerator on an uneven fl oor, it
may cause a height difference between the doors.
When the Freezer part is lower than the
Fridge part.
Insert a fl at-head screwdriver into the hole of the
adjustable leg at the bottom of the freezer door
and turn it clockwise.
(1)
(1)
(2)
(2)
CAUTION
(1)
(1)
CAUTION
CAUTION
(3)
(3)
(2)
(2)
(4)
(4)
(3)
(3)
DA99-03327T(0.1).indb 07DA99-03327T(0.1).indb 07 2012.3.7 7:13:44 PM2012.3.7 7:13:44 PM