User manual

safety information _03
This appliance is not intended for use by
persons (including children) with reduced
physical, sensory or mental capabilities, or
lack of experience and knowledge, unless they
have been given supervision or instruction
concerning use of the appliance by a person
responsible for their safety.
Children should be supervised to ensure that
they do not play with the appliance.
SEVERE WARNING SIGNS
Do not install the refrigerator in a damp
place or place where it may come in
contact with water or gas.
Deteriorated insulation of electrical parts may -
cause an electric shock or fi re.
Do not place this refrigerator in direct sunlight or
expose to the heat from stoves, room heaters
or other appliance.
Allow suffi cient space to install the refrigerator
on a fl at surface.
If your refrigerator is not level, the internal -
cooling system may not work correctly.
Do not plug several appliances into the same
power socket.
The refrigerator should always be plugged into
its own individual electrical socket which has a
voltage rating that matched the rating plate.
This provides the best performance and -
also prevents overloading house wiring
circuits, which could cause a fi re hazard from
overheated wires.
Never unplug your refrigerator by pulling on the
power cord.
Always grip plug fi rmly and pull - Damage to
the cord may cause a short-circuit, fi re and/or
electric shock.
Make sure that the power plug is not squashed
or damaged by the back of the refrigerator.
Do not bend the power cord excessively or
place heavy articles on it.
This constitutes a fi re hazard. -
Have the power cord repaired or replaced
immediately by the manufacturer or its service
agent if power cord has become frayed or
damaged.
Do not use a cord that shows cracks or abrasion
damage along its length or at either end.
If the power cord is damaged, have it replaced
immediately by the manufacturer or its service
agent.
When moving the refrigerator, be careful not to
roll over or damage the power cord.
Do not insert the power plug with wet hands.
Unplug the refrigerator before cleaning and
making repairs.
Do not use a wet or damp cloth when cleaning
the plug.
Remove any foreign matter or dust from the
power plug pins.
Otherwise there is a risk of fi re. -
If the refrigerator is disconnected from the
power supply, you should wait for at least ten
minutes before plugging it back.
If the wall socket is loose, do not insert the
power plug.
There is a risk of electric shock or fi re. -
The appliance must be positioned so that the
plug is accessible after installation.
In the event of a gas leak (such as propane
gas, LP gas, etc.), ventilate immediately without
touching the power plug.
Do not touch the appliance or power cord.
Do not use a ventilating fan. -
A spark may result in an explosion or fi re. -
Do not use a hair dryer to dry the inside of the
refrigerator.
Do not place a lighted candle in the refrigerator
for removing bad odours.
This may result in electric shock or fi re. -
The refrigerator must be grounded.
You must ground the refrigerator to -
prevent any power leakages or electric
shocks caused by current leakage from
the refrigerator.
Never use gas pipes, telephone lines or
other potential lightening rods as ground.
Improper use of the ground plug can result in -
electric shock.
Do not dissemble or repair the refrigerator by
yourself.
You run risk of causing a fi re, malfunction and/ -
or personal injury.
If the appliance generates a strange noise, a
burning or smell or smoke, unplug the power
plug immediately and contact your nearest
service centre.
Keep ventilation opening in the appliance
enclosure or mounting structure clear of
obstruction.
CAUTION
DA99-03327T(0.1).indb 03DA99-03327T(0.1).indb 03 2012.3.7 7:13:42 PM2012.3.7 7:13:42 PM