Specifications

Find Out If You Need to Program the Remote
(on]po_]_]ts (on_]_ct_([ to yo_.lrTV such as a phy_r <to tIt__ollo_-_i_]g:
1. Turn on the component (in this example, a DVD player).
2. Point the remote at the component.
3. Press the corresponding component button (i_ this example, DVD).
4. Press ON,,OFF to see i_ t_te I)V!) player responds. [_ the DVD player doesn't respond, you
need to program the remote to operate it.
Programming the Remote
Th<re are l\vo \_axs lo program lhe remot< (o_trol lo op<rat< other (ompon<_ts: AlHo,,7_(t/i(
Cod(? .5'_?1_'(_?and [)i_'(?(//:'_/ff]'.
Using Automatic Code Search
The }oUov, i,_g ii_structio_]s ca_ 1)e l]se([ to program t_-_eremote lo op(ral( (ac]-_ o_ VOllr
compoi_ei_ts. [_ you \_ant to stop tJte automatic (ode searcl_ \_itJ]out programmi_lg anv o_ vour
compo_<_ts, press and l_ok[ CLEAR u_ti] th< i_](ticator o_ tl_< r<n]ot< turns off.
1+
2+
Turn o_ the compo_e_t you want to operate (VCR, DVI) phyer etc.)
Press and hoIct the compone,_t !)utto,_ you want to program (A[]X or !)VI)). While ttolding
tt_e comp(>,_e_t !)utto_, press an(t hokt ON*OFF until ttte indicator on the remote turns on,
t_te_ release both l>utto_s.
_').
4.
Point the remot<, at the component.
Press and release PLA_ then wait 5 seconds or until the indicator stops _lashing.
At this poi,_t the remote is searching _or t_e correct code to program. [f, a_ier 5 second@ the
compo_e,_t you want to operate c[oes not turn or}, press PLAY again to tell the remote to
search the next set o_ codes.
Co_]ti*_u< pressi_]g and re]<asi_g PLA_ u_ti] tJ]e (ompo_]e_t tur_s o_} or you J_axe s<arcJ_e(t
t__roug]_ aH of t__e codes. T]]e i_([icator turns o_ _h<_ all co(tes l_a\'e 1)e<_ searcl_<(t and
remote exits ALltOI}I_ttJC Co([e S<}_/r(Th.
[_ "[]'t(_ (?()]}]p()I_(.)I]t yOU \\_!_'tt IO (?OI't@()l d()d'_ lllrI't ()_}:
1. [-}r_ssa_3(;treleas_ RE\ERSE, tt-t_3 \_ait 2 seco_3c[s. Repeat this st_p until tPt_ con]po_3e_3t trims
back ON.
22