User Manual
Table Of Contents
- FDR_RF6000T_F-Hub_DA68-04014B-00_EN
- Safety information
- What you need to know about the safety instructions
- Important safety symbols and precautions:
- State of California Proposition 65 Warning
- Important safety precautions
- Severe warning signs for transportation and site
- Critical installation warnings
- Installation cautions
- Critical usage warnings
- Usage cautions
- Cleaning cautions
- Critical disposal warnings
- Installation
- Operations
- Maintenance
- Troubleshooting
- LIMITED WARRANTY (U.S.A.)
- Warranty Information (CANADA)
- Regulatory Notice
- Open Source Announcement
- Safety information
- FDR_RF6000T_F-Hub_DA68-04014B-00_CFR
- Consignes de sécurité
- Ce que vous devez savoir au sujet des consignes de sécurité
- Consignes de sécurité importantes et symboles :
- Avertissement de la proposition 65 de l'État de Californie
- Consignes de sécurité importantes
- Symboles d'avertissement importants concernant le transport et le lieu d'installation de l'appareil
- Avertissements importants concernant l'installation
- Installation en toute sécurité
- Avertissements importants concernant l'utilisation
- Utilisation en toute sécurité
- Nettoyage en toute sécurité
- Avertissements importants concernant la mise au rebut
- Installation
- Opérations
- Maintenance
- Dépannage
- Informations relatives à la garantie (CANADA)
- Avis d'application de la réglementation
- Consignes de sécurité
English 59
Maintenance
• Use only the provided ice bucket. Third-party ice buckets may cause a system failure.
NOTE
• The water pressure required for ice making is between 30 to 120 psi (206 to 827 kPa).
• Noise from the ice maker as it produces ice during the ice making process is normal.
• While the door is open, neither the ice maker nor the water dispenser operates.
Fridge shelves
The appearance of the shelves differs by model.
• To remove a shelf, fully open the
corresponding door. Hold the front of
the shelf, and then gently lift up and
slide out.
NOTE
Do not lift up the shelf fully when
removing or reinserting the shelf. The rear
wall of the fridge room can be dented.
• To reinsert, hold the shelf at an angle
so the front is higher than the back, and
then insert the top hook into the top
shelf notch. Then, lower the shelf and
insert the bottom shelf hook into the
bottom shelf notch.
CAUTION
• The tempered glass shelves are heavy.
Use caution when removing them.
• The shelf must be inserted correctly. Do
not insert upside down.
• Glass containers may scratch the surface
of glass shelves.
Untitled-3 59 2020-03-12 AM 10:59:43










