User Manual

11
ENG
Installing the Display on the Wall Attachment Panel (continued)
➢
The exterior of the PDP may be different than the picture.
(Assembly and installation of the plastic hanger is the same.)
1 Remove the screws from the back of the PDP.
2 Use the screws and assemble the plastic hanger.
3 Tighten the screws of the plastic hanger to the back side of the PDP.
4 Put the 4 pegs on the PDP in the grooves of the wall mount bracket and pull down on the PDP (!) to
secure it to the wall mount bracket (
@). Tighten the screws as shown (#) so that the PDP cannot be
separated from wall mount bracket.
PDP panel
Wall attachment panel bracket Wall
☛
◆ Please ask the installers to install the wall mount bracket.
◆ Please be sure to check if the plastic hanger is
completely secured on both the left and right side after
hanging the PDP on the wall mount bracket.
◆ Please avoid catching your fingers while installing and
adjusting the angle.
◆ Please tightly secure the wall mount bracket to the wall
to avoid injury from a falling PDP.
BN68-00700A-00Eng_0702 7/2/04 4:43 PM Page 11