Technical data

7. Client/Server interface imond
Admin commands
addlink ci-index Add channel to the circuit (channel bundling)
adjust-time seconds Increments the date on the router by the number of
seconds specified
delete filename pw Deletes the file on the router
hup-timeout #ci-index [value] Show or set the HUP timeout for ISDN circuits
removelink ci-index Remove additional channel
reset-telmond-log-file Deletes the telmond log file
reset-imond-log-file Deletes the imond log file
receive filename #bytes pw Transfer a file to the router. Imond acknowledges the
command using an ACK (0x06). After that, the file
is transfered in blocks of 1024 bytes that are also ac-
knowledged with an ACK. Finally, imond replies with
an OK.
send filename pw If the password is correct and the file exists, imond
replies with OK #bytes. Then, imond transfers the file
in blocks of 1024 bytes that have to be acknowledged
with an ACK (0x06). Finally, imond replies with an
OK.
support pw Shows the status/configuration of the router
sync Syncs the cache of mounted drives
Admin or User commands
dial Dials the provider (Default-Route-Circuit)
dialmode [auto|manual|off] Shows or sets the dialmode
disable Hangs up and sets the dialmode to “off”
enable Sets the dialmode to “auto”
halt Cleanly shuts down the router
hangup [#channel-id] Hangs up
poweroff Shuts down the router and powers it off
reboot Reboots the router
route [ci-index] Set the default route to circuit X (0=automatically)
266