Technical data

4. Packages
Driver: 'unknown'
ISA bridge: Advanced Micro Devices [AMD] CS5536 [Geode companion] ISA (rev 03)
Driver: 'unknown'
IDE interface: Advanced Micro Devices [AMD] CS5536 [Geode companion] IDE (rev 01)
Driver: 'amd74xx'
USB Controller: Advanced Micro Devices [AMD] CS5536 [Geode companion] OHC (rev 02)
Driver: 'ohci_hcd'
USB Controller: Advanced Micro Devices [AMD] CS5536 [Geode companion] EHC (rev 02)
Driver: 'ehci_hcd'
In essential 3 network cards are in this machine, driven by ’via_rhine’ and an Atheros-WiFi
card driven by madwifi (the driver name is not resoved correctly here).
OPT_HW_DETECT This variable triggers that the files needed for hardware identification
are copied to the router. Results can either be found on the console while booting if
HW_DETECT_AT_BOOTTIME is set to ’yes’ or in the web interface if OPT_HTTPD (Page 123) was
set to ’yes’. The content of ’/bootmsg.txt’ can of course be checked in the web interface
as well if you have a working network connection to the router.
HW_DETECT_AT_BOOTTIME Starts hardware identification start on boot. Recognition
will take place in background (it will take some time) and then writes its output to
console and ’/bootmsg.txt’.
OPT_LSPCI Listing of all PCI devices
OPT_I2CTOOLS Tools for I
2
C access.
OPT_IWLEEPROM Tool to access the EEPROM of Intel and Atheros WLAN cards.
Needed e.g. to reprogram the regulatory domain on ath9k cards (see http://blog.
asiantuntijakaveri.fi/2014/08/one-of-my-atheros-ar9280-minipcie-cards.html).
OPT_ATH_INFO Hardware diagnosis tool for WLAN cards based on Atheros chipset.
This tool can extract detailed information about the hardware used in Atheros wire-
less cards, e.g. ath5k. These include, amongst others, the chipset used or calibration
information.
4.20.3. File Management Tools
OPT_E3 An editor for fli4l
E3 is a very small editor written in Assembler. It mimics various editor modes known
from other („full size”) editors. To choose a mode e3 only has to be started with the
right command. A short key overview is given by e3 starting without parameter or by
pressing Alt+H (except in VI-mode, press „:h” in CMD mode then). Caret (ˆ) stands
for the Ctrl-/Strg key.
Command Mode
e3 / e3ws WordStar, JOE
e3vi VI, VIM
e3em Emacs
e3pi Pico
e3ne NEdit
227