Technical data

3. Base conﬁguration

CONSOLE_BLANK_TIME='' # time in minutes (1-60) to blank

# console; '0' = never, '' = system default

BEEP='yes' # enable beep after boot and shutdown

SER_CONSOLE='no' # use serial interface instead of or as

# additional output device and main input

# device

SER_CONSOLE_IF='0' # serial interface to use, 0 for ttyS0 (COM1)

SER_CONSOLE_RATE='9600' # baudrate for serial console

#------------------------------------------------------------------------------

# Debug Settings:

#------------------------------------------------------------------------------

DEBUG_STARTUP='no' # write an execution trace of the boot

#------------------------------------------------------------------------------

# Keyboard layout

#------------------------------------------------------------------------------

KEYBOARD_LOCALE='auto' # auto: use most common keyboard layout for

# the language specified in 'LOCALE'

#OPT_MAKEKBL='yes' # set to 'yes' to make a new local keyboard

# layout map on the fli4l-router

#------------------------------------------------------------------------------

# Ethernet card drivers:

#------------------------------------------------------------------------------

# please see file base_nic.list in your config-dir or read the documentation

# If you need a dummy device, use 'dummy' as your NET_DRV

# and IP_NET_%_DEV='dummy<number>' as your device

#------------------------------------------------------------------------------

NET_DRV_N='1' # number of ethernet drivers to load, usually 1

NET_DRV_1='ne2k-pci' # 1st driver: name (e.g. NE2000 PCI clone)

NET_DRV_1_OPTION='' # 1st driver: additional option

NET_DRV_2='ne' # 2nd driver: name (e.g. NE2000 ISA clone)

NET_DRV_2_OPTION='io=0x320' # 2nd driver: additional option

#------------------------------------------------------------------------------

# Ether networks used with IP protocol:

#------------------------------------------------------------------------------

IP_NET_N='1' # number of IP ethernet networks, usually 1

IP_NET_1='192.168.6.1/24' # IP address of your n'th ethernet card and

# netmask in CIDR (no. of set bits)

IP_NET_1_DEV='eth0' # required: device name like ethX

#------------------------------------------------------------------------------

# Additional routes, optional

#------------------------------------------------------------------------------

IP_ROUTE_N='0' # number of additional routes

IP_ROUTE_1='192.168.7.0/24 192.168.6.99'

# network/netmaskbits gateway