Technical data

4. Packages

Figure 4.2.: ﬂi4l conﬁg directory with OpenVPN *.secret ﬁles

OPENVPN_x_BRIDGE Default: OPENVPN_x_BRIDGE=”

Holds the name of the bridge this OpenVPN connection should bind to. If

BRIDGE_DEV_x_NAME=’cuj-br’ is given and the OpenVPN connection should bind to that

bridge ’cuj-br’ has to be set in accordance.

OPENVPN_x_BRIDGE_COST Default: OPENVPN_x_BRIDGE_COST=”

If using spanning tree protocol (STP, see http://de.wikipedia.org/wiki/Spanning_Tree

or documentation for package advanced_networking) you can specify the connection

costs here.

OPENVPN_x_BRIDGE_PRIORITY Default: OPENVPN_x_BRIDGE_PRIORITY=”

If using STP (spanning tree protocol, see http://de.wikipedia.org/wiki/Spanning_Tree

or documentation for package advanced_networking) you can specify connection priority

here.

4.14.4. OpenVPN - Tunnel conﬁguration

OPENVPN_x_REMOTE_VPN_IP Default: OPENVPN_x_REMOTE_VPN_IP=”

This setting is only valid if OPENVPN_x_TYPE (Page 165) is set to ’tunnel’ for this Open-

VPN connection!

VPN IP address of the OpenVPN remote station. VPN IP addresses are needed only for

routing and can be chosen nearly free. The following restrictions apply:

• IP address may not be used in local network and thus can’t be in the subnet of the

ﬂi4l router.

166