Technical data

4. Packages
Typ Karte Needed parameters
Type-numbers for Capi-drivers:
100 Generic CAPI device without ISDN
functionality,
i.e. AVM Fritz!DSL SL
no parameter
101 AVM-B1 PCI no parameter
102 AVM-B1 ISA irq, io
103 AVM-B1/M1/M2 PCMCIA no parameter
104 AVM Fritz!DSL no parameter
105 AVM Fritz!PCI no parameter
106 AVM Fritz!PNP irq, io (from isapnp setup)
107 AVM Fritz!Classic irq, io
108 AVM Fritz!DSLv2 no parameter
109 AVM Fritz!USBv2 no parameter
110 AVM Fritz!DSL USB no parameter
111 AVM Fritz!USB no parameter
112 AVM Fritz!X USB no parameter
113 AVM FRITZ!DSL USBv2 no parameter
114 AVM FRITZ!PCMCIA no parameter
160 AVM Fritz!Box Remote-Capi ip,port
161 Melware Remote CAPI (rcapi) ip,port
Type-Numbers for other drivers:
201 ICN 2B io, mem
Typen-Numbers for mISDN-drivers (experimental):
301 HFC-4S/8S/E1 multiport cards no parameter
302 HFC-PCI based cards no parameter
303 HFCS-USB Adapters no parameter
304 AVM FritZ!Card PCI (v1 and v2) cards no parameter
305 cards based on Infineon (former
Siemens) chips:
- Dialogic Diva 2.0
- Dialogic Diva 2.0U
- Dialogic Diva 2.01
- Dialogic Diva 2.02
- Sedlbauer Speedwin
- HST Saphir3
- Develo (former ELSA) Microlink PCI
(Quickstep 1000)
- Develo (former ELSA) Quickstep
3000
- Berkom Scitel BRIX Quadro
- Dr.Neuhaus (Sagem) Niccy
no parameter
306 NetJet TJ 300 and TJ320 cards no parameter
307 Sedlbauer Speedfax+ cards no parameter
308 Winbond 6692 based cards no parameter
My card is a Teles 16.3 NON-PNP ISA, this is Type=3.
For a ICN-2B-card IO and MEM have to be set, for example ISDN_IO=’0x320’, ISDN_-
MEM=’0xd0000’.
For newer Teles-PCI-card type=20 (instead of 21) has to be used. Those are shown by
148