Installation guide
ADJUSTING
THE
OVEN
BURNER
AIR
ADJUSTMENT
SHUTTERS
All
oven
burners
have
an
air
adjustment
shutter.
The
purpose
of
the
shutter
is
to
regulate
the
flow
of
air
to
the
flames.
Air
Properly
adjusted
flames should
burn
adjustment
steadily
with
approximately
1-in
of
blue
cone.
The
flames should
never
extend
past
the
edge
of
the
burner
baffles.
Even
though
these
are
preset
at
the
factory,
they
should
be
checked
and,
if
needed,
adjusted
periodically
to
ensure
efficient
operation.
To
check
and
adjust
the
oven
burner
air
adjustment
shutters:
Open
the
oven
door.
Remove
the
oven
racks.
SNOLLONGISNI
NOLLY
|
IVISNI
Remove
the
oven
floor.
Press
the
BAKE
pad,
then
the
START
pad.
After the
oven
has
lit,
visually
check
the
flames
coming
out
of
the
upper
and
lower
burners.
If
adjustment
is
needed,
carefully
adjust
the
air
adjustment
shutters.
ao
FB
oO,
=
The
shutters
are
located
at
the
base
of
the
burner
manifolds
near
the
back
oven
wall.
To
adjust
the
shutter,
loosen
the
locking
screw
and
rotate
the
shutter
towards
the
open
or
closed
position
as
needed.
If
flames
are
lifting off
the
burner
ports,
gradually
reduce
the
air
shutter
opening
until
the
flames
are
stabilized.
If
flamrnes
are
too
yellow
and/or
too
large,
gradually
increase
the
air
shutter
opening
until
the
flames
have
approximately
a
1-in
blue
cone.
lf
the
range
is
set
up
for
natural
gas,
the
flames should
burn
with
no
yellow
tipping.
If
the
range
is
set
up
for
LP
gas,
small
yellow
tips
at
the
end
of
the
cones
are
normal.
After
the
flarnes
are
adjusted
properly,
shut
off
the
oven,
retighten
the
locking
screws,
replace
the
oven
bottom
and
racks,
and
close
the
oven
door.
installation
instructions
_37