Quick Guide

16 English
Self-diagnosis
Installation instructions Self-diagnosis
Temp sensor & Heater check
1. After connecting the power, check if the display works properly.
2. Remove all accessories (Gliding Rack, Flat-Rack, Smart Divider...etc.) from
inside of the oven cavity.
3. You cannot proceed with self-diagnosis if the oven cavity is hot or the door is
open.
• In this case, “Hot or door” message appears on the display.
4. To start self-diagnosis, press both Hidden Keys simultaneously for 5 seconds.
• Refer to the table below for the hidden keys for each model.
Model NV51K6650** NV51K7770**
Control panel
Hidden Key
Keep Warm + “9” UPPER + LOWER
and touch "Install test" on
display.
Model NV51*5*****
Control panel
Hidden Key Keep Warm + “9”
A
B
C
A. Trim Left
B. Trim Bottom Large
C. Screw
6. If the cutout size is larger than
3
/4
inches use of the wider bottom trim is
recommended.
NOTE
To select the bottom trim properly, measure
the cutout between cabinet and oven. See
the following chart.
TYPE
Cutout 0 –
3
/4”
3
/4” – 2
3
/4”
IMPORTANT NOTE
Keep oven vent ducts unobstructed. The oven vent is located at the bottom of the
oven. This area could become hot during oven use. Never block this vent or place
plastic or heat-sensitive items in front of it.
Install_NW9000K_DG68-00862A-10_EN+MES+CFR.indb 16Install_NW9000K_DG68-00862A-10_EN+MES+CFR.indb 16 2022-07-27 오후 1:25:012022-07-27 오후 1:25:01