User Manual

E-4
Getting Started
You have just purchased a wired remote controller and it has been installed
by your installation specialist.
Your User’s Manual contain much valuable information on using
your wired remote controller. Please take the time to read them as they will
help you take full advantage of the unit’s features.
In the manual, you will find a series of step-by-step procedures for each
function available.
The illustrations in the step-by-step procedures use 3 different symbols:
PRESS PUSH HOLD DOWN
Wired remote controller
The wired remote controller is installed on the wall.
Note

DIP switch setting is recognized during the initialization. If any changes are
mode to the DIP switch setting after the initialization, you have to initialize
the system by pressing
and or reset the power.

Press the
button after cleaning the air filter.
sign will be off.
The remote controller will display the filter sign to alert the user to clean the
filter and turn off the display when the
button are pressed.

will be displayed if you press the button of the function that the
indoor unit does not support.
ON/OFF timer
/
E
r ror St
atus displ
a y
Ope
r ation mode
displ
a
y
Fan speed
/
Air swing displ
a y
Special fun
ction
displa
y
ON/OFF time setup
Swing but
t on(Except duct type)
Room
tempe
r
atu
r
e
check but
t o
n
Fil
ter
Reset but
t on(Except duct type)
Tempe
r
atu
r e
displ
a y
Ope
r ation ON/OFF but
t o
n
Tempe
r atu
re setting
but
t
o n
Fan speed setting
but
t o
n
Mode sele
ctio
n
(”Quiet“ ”Sleep“:Except duct type)
MWR-WH00_IB_E_31218-1.indd 4 2009-12-14 ｿﾀﾈﾄ 12:52:26